WEDGE Command

GstarCAD 2027 → Commands

Function Description:

This command is used to create 3D solid wedges.
The incline direction is always along the positive direction of the X axis in the UCS.

If the Z value of the specified other corner point is different to the first specified corner point, it will not display height prompt. When specifying height, entering a positive value, the wedge height is created along the positive direction of the Z axis in the current UCS, on the contrary, it will be along the negative direction.

Command Access:

Icon:
Menu: Draw> Modeling > Wedge
Ribbon: 3D > Modeling > Wedge
Toolbar: Modeling > Wedge
Command: WEDGE
Alias: WE

Command Prompts:

Specify first corner or [Center]:   
Specify other corner or [Cube/Length]:   
Specify height or [2Point]:

Specify first corner

Sets the first corner of the wedge base.

Specify other corner

Sets the opposite corner of the wedge base, located on the X,Y plane.

Center

Specifies a center to create a wedge.

Cube: Create an equilateral wedge.
Length: Create a wedge by its length, width and height. The length is along the X axis direction, the width is along the Y axis direction and the height is along the Z axis direction.

Cube

Creates an equilateral wedge.

Length

Creates a wedge by its length, width and height. The length is along the X axis direction, the width is along the Y axis direction and the height is along the Z axis direction.

2Point

Specifies the wedge height by the distance between two specified points.

Related References：

Related Tasks：