WEDGE Command — GstarCAD 2027
WEDGE Command
GstarCAD 2027 · Command Reference
Commands > W Command > WEDGE
Function Description:
This command is used to create 3D solid wedges.
The incline direction is always along the positive direction of the X axis in
the UCS.
If the Z value of the specified other corner point is different to the first specified corner point, it will not display height prompt. When specifying height, entering a positive value, the wedge height is created along the positive direction of the Z axis in the current UCS, on the contrary, it will be along the negative direction.
Command Access:
Icon:
Menu: Draw> Modeling > Wedge
Ribbon: 3D > Modeling > Wedge
Toolbar: Modeling > Wedge
Command: WEDGE
Alias: WE
Command Prompts:
Specify first corner or [Center]:
Specify other corner or [Cube/Length]:
Specify height or [2Point]:
Specify first corner
Sets the first corner of the wedge base.
Specify other corner
Sets the opposite corner of the wedge base, located on the X,Y plane.
Center
Specifies a center to create a wedge.
- Cube: Create an equilateral wedge.
- Length: Create a wedge by its length, width and height. The length is along the X axis direction, the width is along the Y axis direction and the height is along the Z axis direction.
Cube
Creates an equilateral wedge.
Length
Creates a wedge by its length, width and height. The length is along the X axis direction, the width is along the Y axis direction and the height is along the Z axis direction.
2Point
Specifies the wedge height by the distance between two specified points.
Related References：
Related Tasks：
- To Create Boxes
- To Create Cones
- To Create Cylinders
- To Create Spheres
- To Create Pyramids
- To Create a Torus
- To Create Wedges