GstarCAD 2027 · Command Reference
Commands > W Command > WEDGE
Function Description:
This command is used to create 3D solid wedges.
The incline direction is always along the positive direction of the X axis in
the UCS.
If the Z value of the specified other corner point is different to the first specified corner point, it will not display height prompt. When specifying height, entering a positive value, the wedge height is created along the positive direction of the Z axis in the current UCS, on the contrary, it will be along the negative direction.
Command Access:
Icon:
Menu: Draw> Modeling > Wedge
Ribbon: 3D > Modeling > Wedge
Toolbar: Modeling > Wedge
Command: WEDGE
Alias: WE
Command Prompts:
Specify first corner or [Center]:
Specify other corner or [Cube/Length]:
Specify height or [2Point]:
Sets the first corner of the wedge base.
Sets the opposite corner of the wedge base, located on the X,Y plane.
Specifies a center to create a wedge.
- Length: Create a wedge by its length, width and height. The length is along the X axis direction, the width is along the Y axis direction and the height is along the Z axis direction.
Creates an equilateral wedge.
Creates a wedge by its length, width and height. The length is along the X axis direction, the width is along the Y axis direction and the height is along the Z axis direction.
Specifies the wedge height by the distance between two specified points.
Related References：
Related Tasks：
Article ID: 2880
Created: September 26, 2026
Last Updated: September 25, 2026
Author: kbadmin
Online URL: https://kb.gstarcad.com.my/article/wedge-command-gstarcad-2027-2880.html
