OFFSET Command — GstarCAD 2027
OFFSET Command
GstarCAD 2027 · Command Reference
Commands > O Command > OFFSET
Function Description:
This command is used to create concentric circles, parallel lines and parallel curves.
Users can offset a selected object by a specified distance or a point. After
offsetting objects, users can use the TRIM or EXTEND command to create drawings with several parallel lines and curves.
For the convenience of use, the OFFSET command will not stop prompting until
you press Enter to exit.
Command Access:
Icon:
Menu: Modify > Offset
Ribbon: Home > Modify > Offset
Toolbar: Modify > Offset
Command: OFFSET
Alias: O
Command Prompts:
Specify offset distance or [Through/Erase/Layer] \<Through>:
Offset distance
Creates an object by a specified distance from the selected object.
- Exit: Exits the OFFSET command.
- Undo: Restores the last offset.
Through
Creates an object through a specified point.
- Exit: Exits the OFFSET command.
- Undo: Restores the last offset.
Erase
Erases the source object after offsetting.
Layer
Applies the current layer or source layer on an object for offsetting.
- Current: Applies current layer on the selected object for offsetting.
- Source: Applies source layer on the selected object for offsetting.
Related References：
Related Concepts：
Related Tasks：