DONUT Command — GstarCAD 2027
DONUT Command
GstarCAD 2027 · Command Reference
Commands > D Command > DONUT
Function Description:
This command is used to create a solid circle or a wide ring.
A donut consists of two arc polylines that are joined end-to-end to create a
circular shape. The width of the polylines is determined by the specified inside and outside diameters.
If you specify an inside diameter of 0, the donut is a filled circle.
Command Access:
Icon:
Menu: Draw > Donut
Ribbon: Home > Draw > Donut
Toolbar: /
Command: DONUT
Alias: DO
Command Prompts:
Specify inside diameter of donut
:
Specify outside diameter of donut :
Specify center of donut or \<exit>:
Inside diameter of donut
Specifies the inside diameter of the donut.
Outside diameter of donut
Specifies the outside diameter of the donut.
Center of donut
Specifies the location of the donut based on its center point. A donut is drawn at each point specified until you press Enter to end the command.
Related References：
Related Tasks：