REBUILD2DDEGREE System Variable — GstarCAD 2027
REBUILD2DDEGREE System Variable
GstarCAD 2027 · Command Reference
Function Description:
The REBUILD2DDEGREE system variable is used to set the global degree when rebuilding a spline.
| Type | Integer |
| Saved in | Registry |
| Initial value | 3 |
| Range | 1 \~ 11 |
If the degree is 1, it rebuilds a straight line; if the degree is 2, it rebuilds a curve with one bend. A Bezier curve has a degree of 3. It can rebuild more complex curves with higher degrees, but computations are required.