MLINE Command — GstarCAD 2027
MLINE Command
GstarCAD 2027 · Command Reference
Commands > M Command > MLINE
Function Description:
This command is used to create multiple parallel lines.
Command Access:
Icon:
Menu: Draw > Multiline
Ribbon: /
Toolbar: /
Command: MLINE
Alias: ML
Command Prompts:
Specify start point or [Justification/Scale/STyle]:
Start point
Specifies the start point of multiple lines.
It displays Close option when creating a multiple line by two or more line segments.
- Next point: Draws a multiple line to the specified point using the current multiline style and continues to prompt entering next point.
- Undo:
Undoes the last vertex on the multiple lines.
- Close:
Closes the multiple lines by end to end.
Justification
Determines how to create multiple lines among the specified points.
- Top: Draws multiple lines under the cross cursor. The maximum positive offset line appears at the specified point.
- Zero:
Places the cross cursor to origin and draws multiple lines. The element
properties of the MLSTYLE command can specify the offset to 0.0.
- Bottom: Draws multiple lines above the
cross cursor. The line with maximum negative offset appears at the specified
point.
Scale
Controls the whole width of multiple lines. It does not affect the linetype scale.
The scale is based on the width created in multiple line style. When the
scale is set to 2, the width is double of the defined value. The negative scale overturns
the order of lines: when drawing multiple lines from left to right, the minimum
offset lines are drawn on the top. The absolute value of negative scale factor affects the scale. Specifying
the scale factor to 0, it makes multiple lines become a single line.
STyle
Specifies the style of multiple lines. Users can reference the MLSTYLE command.
- Style name: Specifies the loaded style name or created style names that defined in multiple lines library (MLN).
- [?]: Displays the loaded styles of multiple lines.
Related References：
Related Tasks：