Modify Text — GstarCAD 2027
Modify Text
Text Height
Command Entry: TXT40
1.Start the command.
2.Select a single line text.
3.Input text height.
4.Press enter to finish the command.
Width Factor
Command Entry:TXT41
1.Start the command.
2.Select a single line text.
3.Input Width height ratio.
4.Press enter to finish the command.
Angular
Command Entry:TXT50
1.Start the command.
2.Select a single line text.
3.Input rotation angle.
4.Press enter to finish the command .
Obliquing Angle
Different to the rotation angle, after executing the command, the text will get an inclination deformation effect.
Command Entry:TXT51
1.Start the command.
2.Select a single line text.
3.Input tilt angle.
4.Press enter to finish the command.
Options
You can use this function to modify all the options above.
Command Entry: EDTXT