DWGCHECK System Variable — GstarCAD 2027
DWGCHECK System Variable
GstarCAD 2027 · Command Reference
Function Description:
The DWGCHECK system variable is used to check whether there exists potential problem when opening drawings.
| Type | Integer |
| Saved in | Registry |
| Initial value | 1 |
| Range | 0,1,2,3 |
System Variable Value:
0: if a drawing that you try to open has a potential problem, you are warned before the drawing is opened
1: if a drawing that you try to open has a potential problem, or if it was saved by an application other than one based on RealDWG, you are warned before the drawing is opened
2: if a drawing that you try to open has a potential problem, you are notified at the Command prompt
3: if a drawing that you try to open has a potential problem, you are notified at the Command prompt. If the drawing has a potential problem and the drawing was saved by an application other than one based on RealDWG, you are warned before the drawing is opened