# To Enter Commands [GstarCAD 2027](Help%20System/GSTARCAD/2027/Index.md) → [Commands](Help%20System/GSTARCAD/2027/Commands/(Commands).md) → [Procedures](Help%20System/GSTARCAD/2027/Commands/01%20Procedures/(Procedures).md) **To Enter a Command on the Command Line** You can use one of the following methods to enter the command: - At the command prompt, type the full command name and press Enter or Spacebar. - If Auto-Append is turned on, start typing the command. Press Enter when the correct command is highlighted in the command text area. - Enter the command alias (a shorter, alternate name that is stored in the .pgp file) and press Enter. **To Reuse a Recently Used Command** You can use one of the following methods: - Click within the command line and press the Up or Down Arrow key to cycle through commands you have entered. - Right-click the command line and select Recent Commands. - Right-click the drawing area and select a command from the Recent Input list. **To Repeat a Command** You can use one of the following methods: - With the cursor at the command prompt, press Enter or the Spacebar after the command is complete. - Enter the MULTIPLE command at the command prompt, it prompts you to enter the command name to repeat. **To Complete a Command Entry** You can use one of the following methods: - Press Enter. - Press the Spacebar. - Right-click and select Enter or just right-click (depending on right-click behavior settings). **To Cancel a Command** Press Esc. --- [Original help](https://www.gstarcad.net/help/GstarCAD_2027_en-US/detail/commandReferences/To%20Enter%20Commands.html) · © Gstarsoft Co., Ltd.