# To Draw a Rectangle [GstarCAD 2027](Help%20System/GSTARCAD/2027/Index.md) → [Commands](Help%20System/GSTARCAD/2027/Commands/(Commands).md) → [Procedures](Help%20System/GSTARCAD/2027/Commands/01%20Procedures/(Procedures).md) **To Draw a Rectangle** 1. Click Draw > Rectangle on the main menu. 2. Specify the first corner point. 3. Specify the other corner point. **To Draw a Rectangle By Length and Width** 1. Click Draw > Rectangle on the main menu. 2. Specify the first corner point. 3. Enter D (Dimensions) at the command prompt. 4. Specify the length for rectangles. 5. Specify the width for rectangles. 6. Specify other corner point **To Draw a Rectangle By Area** 1. Click Draw > Rectangle on the main menu. 2. Specify the first corner point. 3. Enter A (Area) at the command prompt. 4. Enter the area of the rectangle in current units. 5. Enter L to enter the length. The width is calculated based on the length and the area. You can either enter W to enter the width. The length is calculated based on the width and the area. 6. Enter the rectangle length or width. **To Draw a Rectangle With Rotation** 1. Click Draw > Rectangle on the main menu. 2. Specify the first corner point. 3. Enter R (Rotation) at the command prompt. 4. Specify a rotation angle. 5. Specify the other corner point. --- [Original help](https://www.gstarcad.net/help/GstarCAD_2027_en-US/detail/commandReferences/To%20Draw%20a%20Rectangle.html) · © Gstarsoft Co., Ltd.