# WEDGE Command
[GstarCAD 2022](Help%20System/GSTARCAD/2022/Index.md) → [Commands](Help%20System/GSTARCAD/2022/Commands/(Commands).md) → [W](Help%20System/GSTARCAD/2022/Commands/W/(W).md)
## Function Description:
This command is used to create 3D solid wedges.
The incline direction is always along the positive direction of the X axis in
the UCS.
If the Z value of the specified other corner point is different to the first
specified corner point, it will not display height prompt. When specifying
height, entering a positive value, the wedge height is created along the positive direction of
the Z axis in the current UCS, on the contrary, it will be along the negative direction.
## Command Access:
> **Icon:**
> 
> **Menu:** Draw\> Modeling \> Wedge
> **Ribbon:** 3D \> Modeling \> Wedge
> **Toolbar:**
> Modeling \> Wedge
> **Command:** WEDGE
> **Alias:**
> WE
## Command Prompts:
Specify first corner or \[Center\]:
Specify other corner or \[Cube/Length\]:
Specify height or \[2Point\]:
## **Specify first corner**
Sets the first corner of the wedge base.
## **Specify other corner**
Sets the opposite corner of the wedge base, located on
the X,Y plane.
## **Center**
Specifies a center to create a wedge.
## **Cube**
Creates an equilateral wedge.
## **Length**
Creates a wedge by its length, width and height. The length is along the X axis direction, the width is along the Y axis direction and the height is along the Z axis direction.
## **2Point**
Specifies the wedge height by the distance between two specified points.