# DONUT Command [GstarCAD 2022](Help%20System/GSTARCAD/2022/Index.md) → [Commands](Help%20System/GSTARCAD/2022/Commands/(Commands).md) → [D](Help%20System/GSTARCAD/2022/Commands/D/(D).md) ## Function Description: This command is used to create a solid circle or a wide ring. A donut consists of two arc polylines that are joined end-to-end to create a circular shape. The width of the polylines is determined by the specified inside and outside diameters. If you specify an inside diameter of 0, the donut is a filled circle. ## Command Access: > **Icon:** >  > **Menu:** Draw \> Donut > **Ribbon:** Home \> Draw \> Donut > **Toolbar:** / > **Command:** DONUT > **Alias:** DO ## Command Prompts: Specify inside diameter of donut : Specify outside diameter of donut : Specify center of donut or \<exit\>: ## Inside diameter of donut Specifies the inside diameter of the donut.  ## Outside diameter of donut Specifies the outside diameter of the donut. ## Center of donut Specifies the location of the donut based on its center point. A donut is drawn at each point specified until you press Enter to end the command.