# Mtext Editor Improvement [GstarCAD 2021](Help%20System/GSTARCAD/2021/Index.md) → [What's new](Help%20System/GSTARCAD/2021/What's%20new/(What's%20new).md) New enhancement of MText editor supports Numbering, Superscript, Subscript, Combining Paragraphs, Matching Text format and Adding Deletelines to selected text.  **Options in Numbering list:**  **Off**: Remove letters, numbers and bullets from the selected text to which the list format is applied. Does not change the indentation state. **Lettered**: Apply a list format that uses letters with periods for items in the list. If the list contains more items than letters, you can continue the sequence with two letters. **Numbered:** Apply a list format that uses numbers with periods for items in the list. **Bulleted:** Apply a list format that uses bullets for items in the list. **Start:** Start a new sequence of letters or numbers in the list format. If the selected item is in the middle of the list, the unselected items below the selected item will also become part of the new list. **Continue:** Add the selected paragraph to the last list above and continue the sequence. If a list item is selected instead of a paragraph, the unselected items below the selected item will continue the sequence. **Allow Auto Bullets and Numbering:** Apply list formatting as you type. The following characters can be used as punctuation after letters and numbers but cannot be used as bullets: period “.”comma “,”, right bracket “)”, right angle bracket “\>”, right square bracket “\]”, and right curly brackets “}”. **Allow Bullets and Lists:** If you select this option, the list format will be applied to all plain text in multi-line text objects that look like lists. - **Upgrade and downgrade of serial Numbers:** - Press Tab to increase the selected list item by one level. - Press Shift\+Tab key to lower the selected list item by one level. - Press Enter to continue Numbering. - Press Shift\+Enter to end Numbering. --- Gstarsoft Co.,Ltd