# 3DPOLY Command [GstarCAD 2019](Help%20System/GSTARCAD/2019/Index.md) → [Commands](Help%20System/GSTARCAD/2019/Commands/(Commands).md) → [3D](Help%20System/GSTARCAD/2019/Commands/3D/(3D).md) The 3DPOLY command is used to create 3D polylines. ## Command Access: > **Ribbon:** Home \> Draw \> 3D Polyline > **Menu:**Draw \> 3D Polyline > **Command:** 3DPOLY ## Command Prompts: Specify start point of polyline: Specify endpoint of line or \[Undo\]: Specify endpoint of line or \[Undo\]: Specify endpoint of line or \[Close/Undo\]: …… Specify endpoint of line or \[Close/Undo\]: ## Function Description: The 3D polyline is a sequence as a single object that combined by connected straight lines; those straight lines could in different plane, but could not contain arc segment.  **Relative Glossary:** **Endpoint:** Draw a straight line from the start point to the specified point. It will not stop prompting until pressing ENTER. **Undo:**Remove the last drawn straight line and redraw from the last point. **Close:** Draw a line to close the 3D polyline from the end point to the start point and exit the command. To close 3D polyline, there must be at least two line segments. ## Other versions with matching text [GstarCAD 2018](Help%20System/GSTARCAD/2018/Commands/3D/3DPOLY%20Command.md) · [GstarCAD 2020](Help%20System/GSTARCAD/2020/Commands/3D/3DPOLY%20Command.md) · [GstarCAD 2021](Help%20System/GSTARCAD/2021/Commands/3D/3DPOLY%20Command.md)