# SPLINE Command [GstarCAD 2015](../../Index.md) → [Commands](../%28Commands%29.md) → [S](%28S%29.md) ## Function Description: > Create a smooth curve that passes through or near selected points. **Menu:** > Draw\>Spline **Command Entry:** > SPLINE **Command Prompt:** > Create a smooth curve that passes through or near selected points. > > Second point: > > \[Close/Fit tolerance\]\<Next point\>: > > **Next point** > > Continuing to enter points adds additional spline curve segments until you press ENTER. Enter > *undo* to remove the last point specified. Once you press ENTER, you are prompted to specify the start tangent for the spline curve. > > Select starting tangent point: > > Enter tangent for ending point: > > **Close** > > Close the spline curve by defining the last point as co-incident with the first and making it tangent to the joint. > > Enter tangent: > > Specify a point to define the tangent vector or use the Tangent and Perpendicular object snap modes to make the spline tangent or perpendicular to existing objects. > > **Fit tolerance** > > Change the tolerance for fitting of the current spline curve. The spline curve is redefined so that it fits through the existing points according to the new tolerance. You can repeatedly change the fit tolerance, but doing so changes the fit tolerance for all the control points regardless of the control point that is selected. > > Enter fit tolerance (in drawing units) \<Current\>: > > If you set the tolerance to 0, the spline curve passes through the fit points. Entering a tolerance greater than 0 allows the spline curve to pass through the fit points within the specified tolerance. > > SPLINE returns to the previous prompt. ## Other versions with matching text [GstarCAD 8 (2013–2014)](../../../2013/Commands/S/SPLINE%20Command.md)