# ORTHO Command
[GstarCAD 2015](../../Index.md) → [Commands](../%28Commands%29.md) → [O](%28O%29.md)
Constrain cursor movement to the horizontal or vertical direction.
## Command Access:
> **Command entry:** ORTHO
## Command Prompts:
> When system variable ORTHOMODE is 1, the following prompt is displayed:
>
> ORTHOMODE is currently on: \[OFF/Toggle/On\]\<On\>: *Enter off or t or press* ENTER.
>
> When system variable ORTHOMODE is inactive, ORTHOMODE value is 0, the following prompt is displayed:
>
> ORTHOMODE is currently off: \[ON/Toggle/Off\]\<Off\>: *Enter on or t or press* ENTER.
>
> Ortho mode is used when you specify an angle or distance by means of two points using a pointing device. In Ortho mode, cursor movement is constrained to the horizontal or vertical direction relative to the UCS.
## Other versions with matching text
[GstarCAD 8 (2013–2014)](../../../2013/Commands/O/ORTHO%20Command.md)