# "Drawing Unit"Dialog Box
[GstarCAD 2015](../../Index.md) → [Commands](../%28Commands%29.md) → [03 Dialog Boxes](%28Dialog%20Boxes%29.md)
## Function Description:
> Define the unit and angle format.
**Command Entry:**
> UNITS
## Dialog Box Description:
> **Length**
>
> Specify the current unit of measurement and the precision for the current unit.
>
> Type
>
> Set the current format for unit of measure. The value include Architectural, Decimal, Engineering, Fractional, and Scientific. The Engineering and Architectural format produce feet-and-inches display and assume that each drawing unit represents one inch. The other formats can represent any real-world unit.
>
> **Precision**
>
> Set the number of decimal place or fractional size displayed for linear measurements.
>
> **Angle**
>
> Specify the current angle format and the precision for the current angle display.
>
> **Type**
>
> Set the current angle format.
>
> **Precision**
>
> Set the precision for the current angle display.
>
> The following conventions are used for the various angle measures: decimal degrees appear as decimal numbers, grads appear with a lowercase *g* suffix, and radians appear with a lowercase r suffix. The degrees/minutes/seconds format uses d for degrees, ' for minutes, and " for seconds; for example:
>
> 123d45'56.7"
>
> Surveyor's unit show angle as bearings, using N or S for north or south, degrees/minutes/seconds for how far east or west the angle is from direct north or south, and E or W for east or west; for example:
>
> N 45d0'0" E
>
> The angle is always less than 90 degrees and is displayed in the degrees/minutes/seconds format. If the angle is precisely north, south, east, or west, only the single letter representing the compass point is displayed.
>
> Clockwise
>
> Calculate positive angle in the clockwise direction. The default direction for positive angle is counterclockwise.
>
> When prompted for an angle, you can point in the desired direction or enter an angle regardless of the setting specified for Clockwise.
>
> **Sample Output**
>
> Display an example of the current setting for unit and angle.
>
> **Direction**
>
> Display the Direction Control Dialog Box.
## Other versions with matching text
[GstarCAD 8 (2013–2014)](../../../2013/Commands/03%20Dialog%20Boxes/Drawing%20Unit-Dialog%20Box.md)