# REVSURF Command [GstarCAD 2012](../../Index.md) → [Commands](../%28Commands%29.md) → [R](%28R%29.md) ## Function Description: > Creates a revolved mesh about a selected axis **Menu:** > Draw\>Modeling\>Mesh\>Revolved Mesh **Command Entry:** > REVSURF **Command Prompt:** > Select an entity to revolve: Select a line, arc, circle, or 2D or 3D polyline > > Select the axis of revolution: Select a line or open 2D or 3D polyline > > The path curve is swept about the selected axis to define the mesh. The path curve defines the N direction of the mesh. Selecting a circle or a closed polyline > as the path curve closes the mesh in the N direction. > > The vector from a polyline's first vertex to its last vertex determines the rotation axis. Any intermediate vertices are ignored. The axis of revolution determines the M direction of the mesh. > > Specify start angle \<0\>: Enter a value or press ENTER > > Specify included angle (\+\=ccw, -\=cw) \<360\>: Enter a value or press ENTER > > **Start Angle** > > If set to a nonzero value, begins the mesh of revolution at an offset from the generating path curve. > > **Included Angle** > > Specify how far about the axis of revolution the mesh extends. > > Specify a start angle begins the mesh of revolution at an offset from the generating path curve. The included angle is the distance through which the path curve is swept. > > Enter an included angle that is less than a full circle prevents the circle from closing. > > The point you use to select the axis of revolution affects the direction of revolution. Each of the meshes in the examples below was created by specifying a start angle of 0 degrees and an included angle of 90 degrees. > > The density of the generated mesh is controlled by the SURFTAB1and SURFTAB2 system variables. SURFTAB1 specifies the number of tabulation lines that are drawn in the direction of revolution. If the path curve is a line, arc, circle, or spline-fit polyline, SURFTAB2 specifies the number of tabulation lines that are drawn to divide it into equal-sized intervals. If the path curve is a polyline that has not been spline fit, tabulation lines are drawn at the ends of straight segments, and each arc segment is divided into the number of intervals specified by SURFTAB2. ## Other versions with matching text [GstarCAD 2011](../../../2011/Commands/R/REVSURF%20Command.md)