# PLINE Command [GstarCAD 2012](../../Index.md) → [Commands](../%28Commands%29.md) → [P](%28P%29.md) **Function Description:** > Create a 2D polyline **Menu:** > Draw \>Polyline **Command Entry:** > PLINE Command Prompt: > Start of polyline:Specify a point 1 > > \[Arc/Distance/Halfwidth/Width\]\<Next point\>: Specify next point 2 or enter an option > > \[Arc/Close/Distance/Follow/Halfwidth/Width/Undo\]\<Next point\>: > > **Next point** > > Draw a line segment. The previous prompt is repeated. > > **Arc(A)** > > Add arc segments to the polyline. > > **Close(C)** > > Draw an arc segment from the last point specified to the starting point, creating a closed polyline. At least two points must be specified to use this option. > > **Distance(D)** > > Specify the distance for segment in polyline. > > Distance for segment: Specify segment distance. > > Angle of segment: Specify segment angle. > > **Follow(F)** > > If the last object is a line segment, the new line segment will be drawn with the same angle as the last. > > If the last object is an arc, the new line segment will be drawn tangent with the arc > . > > **Halfwidth(H)** > > Specify the width from the center of a wide polyline segment to one of its edges. > > Specify starting half-width \<current\>: Enter a value or press ENTER. > > Specify ending half-width \<starting width\>: Enter a value or press ENTER. > > **Width(W)** > > Specify the width of the next arc segment. > > Specify starting width \<current\>: Enter a value or press ENTER. > > Specify ending width \<starting width\>: Enter a value or press ENTER. > > **Undo(U)** > > Remove the most recent arc segment added to the polyline. ## Other versions with matching text [GstarCAD 2011](../../../2011/Commands/P/PLINE%20Command--18042fe4e133.md)