# ORTHO Command [GstarCAD 2012](../../Index.md) → [Commands](../%28Commands%29.md) → [O](%28O%29.md) **Function Description:** > Constrain cursor movement to the horizontal or vertical direction. **Command Entry:** > ORTHO Command Prompt: > After you enter ORTHO at Command line. > > When system variable ORTHOMODE is 1, the following Command prompt is > displayed: > > ORTHOMODE is currently on: \[OFF/Toggle/On\]\<On\>: Enter off or t or press ENTER. > > When system variable ORTHOMODE is inactive state namely: > ORTHOMODE value is 0, the following Command prompt is displayed: > > ORTHOMODE is currently off: \[ON/Toggle/Off\]\<Off\>: Enter on or t or press ENTER. > > Ortho mode is used when you specify an angle or distance by means of two points using a pointing device. In Ortho mode, cursor movement is constrained to the horizontal or vertical direction relative to the UCS. ## Other versions with matching text [GstarCAD 2011](../../../2011/Commands/O/ORTHO%20Command--8e762e0d4e60.md)