# IMAGECLIP Command [GstarCAD 2012](../../Index.md) → [Commands](../%28Commands%29.md) → [I](%28I%29.md) ## Function Description: > Use clipping boundaries to define a subregion of an image object Menu: > Modify\>Clip\>Image Command Entry: > IMAGECLIP **Command Prompt:** > Select image to clip: *Select an edge of an image* > > Enter image clipping option \[ON/OFF/Delete/New boundary\] \<New\>: Enter an option or press ENTER > > The boundary you specify must be in a plane parallel to the image object > > **New Boundary** > > Specify a new clipping boundary. The boundary can be rectangular or polygonal, and consists only of straight line segments. When defining a clipping boundary, specify vertices within the image boundary. Self-intersecting vertices are valid. Rectangular is the default option. If you use the pointing device to specify a point at the Enter Clipping Type prompt, the point is interpreted as the first corner of a rectangle. > > Enter clipping type \[Polygonal/Rectangular\] \<Rectangular\>: Enter p or press ENTER > > **Rectangular** > > Specify a rectangular boundary by its opposite corners. The rectangle is always drawn parallel to the edges of the image. > > Specify first corner point: Specify a point > > Specify opposite corner point: Specify a point > > **Polygonal** > > Use specified points to define a polygonal boundary. > > Specify first point: Specify a point > > Specify next point or \[Undo\]: Specify a point or enter u > > Specify next point or \[Undo\]: Specify a point or enter u > > Specify next point or \[Close/Undo\]: Specify a point, or enter c or u > > You must specify at least three points to define a polygon. > > If the image already has a clipping boundary defined, the following prompt is displayed: > > Delete old boundary? \[No/Yes\] \<Yes\>: Enter n or press ENTER > > If you choose Yes, the entire image is redrawn and the Command continues; if you choose No, the Command ends. > > **On** > > Turn on clipping and displays the image clipped to the previously defined boundary. > > **Off** > > Turn off clipping and displays the entire image and frame. > > If you reclip the image while clipping is turned off, clipping is automatically turned back on. You are prompted to delete the old boundary even when clipping is turned off and the clipping boundary is not visible. > > **Delete** > > Remove a predefined clipping boundary and redisplays the full original image. ## Other versions with matching text [GstarCAD 2011](../../../2011/Commands/I/IMAGECLIP%20Command.md)